AT0-11-120AMT-ZBZ/X

Electro-Magnet Safety Interlock Switch

Electro-Magnet Activated Interlock Switch
(power required to activate interlock)
With interlock monitoring and auxiliary release mechanism
Monitoring of door position: continuous

The operating head can be turned manually in 90° stages to match the specified plane of actuation.

*This product has been retired and replaced by a new part. Please contact us for new part information.

Electro-Magnet Safety Interlock Switch AT0-11-120AMT-ZBZ/X Electro-Magnet Safety Interlock Switch AT0-11-120AMT-ZBZ/X
Contacts	Voltage	Contact Sequence
Normally Open	Normally Closed	120 V 50/60 Hz
1	1	AT0-11-120AMT-ZBZ/X

Contacts

Voltage

Contact Sequence

Normally
Open

Normally
Closed

120 V 50/60 Hz

Actuators for combination with the AT0 and LS Locks Actuators for combination with the AT0 and LS Locks View More
G-ZBZ	W-ZBZ	F-ZBZ	FG-ZBZ	NG-ZBZ	NW-ZBZ
LS-XG-ZBZ	LS-XW-ZBZ	LS-XF-ZBZ	LS-XFG-ZBZ	LS-XNG-ZBZ	LS-XNW-ZBZ
Straight actuator for sliding doors	Angled actuator for swing doors ≥ 250 mm width	Angled flexible actuator for doors which do not close precisely	Straight flexible actuator for doors which do not close precisely	Straight actuator with overlap, with increased tolerance in the direction of closing	Angled actuator with overlap, with increased tolerance in the direction of closing
The operating head can be turned manually in 90° stages to match the specified plane of actuation.			The spring-powered AT0-..-...FT-ZBZ is equipped with a release mechanism which can be accessed with a screwdriver to deactivate the interlock in the event of a power loss (e.g. during start-up). This auxiliary release mechanism must be sealed during normal operation!
The operating head can be turned manually in 90° stages to match the specified plane of actuation.
The spring-powered AT0-..-...FT-ZBZ is equipped with a release mechanism which can be accessed with a screwdriver to deactivate the interlock in the event of a power loss (e.g. during start-up). This auxiliary release mechanism must be sealed during normal operation!
*For degree of protection IP 65, use cable gland M20 with a maximum connection thread length of 9.5mm (V-M20)
*Switch must never be used as a mechanical stop!