KMParts.com is "THE" source for industrial automation control components
AT0-02-120AMT-ZBZ/X
Electro-Magnet Safety Interlock Switch
AT0-02-120AMT-ZBZ/X
Electro-Magnet Safety Interlock Switch
AT0-02-120AMT-ZBZ/X
Electro-Magnet Safety Interlock Switch
- Electro-Magnet Activated Interlock Switch
(power required to activate interlock) - With interlock monitoring and auxiliary release mechanism
- Monitoring of door position: continuous
The operating head can be turned manually in 90° stages to match the specified plane of actuation.
*This product has been retired and replaced by a new part. Please contact us for new part information.
Electro-Magnet Safety Interlock Switch AT0-02-120AMT-ZBZ/X
Electro-Magnet Safety Interlock Switch AT0-02-120AMT-ZBZ/X
|
|||
|---|---|---|---|
| Contacts | Voltage | AT0-02-120AMT-ZBZ/X | |
| Normally Open |
Normally Closed |
120 V 50/60 Hz | |
| - | 2 |  View PDF |
|
| Positive Opening Clearance to IEC/EN 60 947-5-1 | Contact Sequence | ||
 |
 |
||
Actuators for combination with the AT0 and LS LocksActuators for combination with the AT0 and LS LocksView More
|
|||||
|---|---|---|---|---|---|
| G-ZBZ | W-ZBZ | F-ZBZ | |||
| LS-XG-ZBZ | LS-XW-ZBZ | LS-XF-ZBZ | |||
Straight actuator for sliding doors |
Angled actuator for swing doors ≥ 250 mm width |
Angled flexible actuator for doors which do not close precisely |
|||
|
The operating head can be turned manually in 90° stages to match the specified plane of actuation. |
The spring-powered AT0-..-...FT-ZBZ is equipped with a release mechanism which can be accessed with a screwdriver to deactivate the interlock in the event of a power loss (e.g. during start-up). This auxiliary release mechanism must be sealed during normal operation! |
||||
|
The operating head can be turned manually in 90° stages to match the specified plane of actuation. |
|||||
|
The spring-powered AT0-..-...FT-ZBZ is equipped with a release mechanism which can be accessed with a screwdriver to deactivate the interlock in the event of a power loss (e.g. during start-up). This auxiliary release mechanism must be sealed during normal operation! |
|||||
| *For degree of protection IP 65, use cable gland M20 with a maximum connection thread length of 9.5mm (V-M20) | |||||
| *Switch must never be used as a mechanical stop! | |||||
AT0 & LS Actuators
Straight Actuator
for Sliding Doors
Angled Actuators
for Swing Doors
Angled Flexible
Actuator
Straight Flexible
Actuator
Straight Actuator
with Overlap
Angled Actuator
with Overlap
- Phone: +1-866-595-9616
- Fax: +1-941-473-0987
- Email: sales@kmparts.com
- Address: 1580 Market Cir #1
- Port Charlotte, FL 33953
- Hours: M-F 7:30a.m. - 5:30p.m. EDT
