Eaton Moeller
SL-B Stacklight Base Module
with Screw Terminal

Base Module

Connection Type = Screw Terminals

Part Number = SL-B

Setting Jumpers

Built-in jumpers are used in stack light modules to determine the wiring position.

The jumper of the bottom-most module should be set to position 1; this is the supplied jumper position for all modules.

When a second module is added on top of the first, the jumper must be moved to position 2.

The jumper of the third module must be moved to position 3, and so on.

A maximum of five modules may be added to a stack light.

Stacklight Technical Information

General
Standards	IEC/EN 60947
Degree of protection, IEC/EN 60529	IP65 with SL-IP65 gasket; IP20 with SL-A acoustic indicator module
Climatic proofing	Damp heat, constant, to IEC 60068-2-78; Damp heat, cyclical, to IEC 60068-2-30
Ambient temperature Enclosed [°C]	- 25 / 50
Mounting position	As required
Mechanical shock resistance according to IEC 60068-2-27 Shock duration 11 ms, half-sinusoidal [g]	> 15
Terminal Capacity Solid [mm₂] Stranded [mm₂]	0.75 – 2.5 0.5 – 2.5
Contacts
Rated impulse withstand voltage U^imp [V AC]	4000
Rated insulation voltage Ui [V]	250
Overvoltage category / pollution degree	III / 3

ASI Base Module

General
Connection of the AS interface line	Screw terminal on the circuit board
Addressing	Through AS interface line connection
Maximum total current [mA]	≤ 250
Power supply	From AS interface line only
Ambient temperature [°C]	-25 / 55
Status LEDs on the circuit board	Status. Output Q0/function module position 1: green Status. Output Q1/function module position 2: green Status. Output Q2/function module position 3: green AS interface power line: green AS interface error, AS interface master failure: red
Profile	S-9.A.E

Stacklight Dimensions