Standard N9-250 Breakers have 3 power wires in (L1-L2-L3) on the top, and 3 power wires out (T1-T2-T3) on the bottom.

Any other control wires will indicate some sort of modification accessory is installed!

By UL code breakers can only be modified at our UL Approved service facilities.
They cannot be installed in the field or by distributors. In order to get the correct breaker to you, it is imperative that we have the correct information due to the wide variety of options that may be installed on your current breaker.

Accessories can be identified by small labels on the breaker, with part numbers such as

a.                   (u-nzm9) (230, 60) Indicates under voltage trip which needs 230 volt 60hz applied to turn the breaker on.

b.                   (a-nzm9) (230,60) Indicates shunt trip which needs 230 volt 60hz applied to turn the breaker off.

c.                   (rhi, nhi, ahi -xx) Would be auxiliary contacts.

 If the labels cannot be read on your N9-250 or to double check their usage record all the terminal numbers that have control wires on them, and your KMparts  Specialist will advise you of your best options.

 Please note any of the above when ordering. Also check to see if they are even used. If they are present but there are no wires on them then chances are you don’t need them.