Standard Auxiliary Contacts

• - 1NO/1NC
• - Installs on left side of FAZ or shunt trip
• - Max. one per FAZ (1077) device
• - Switches when FAZ is tripped
• - Electrically or manually

• - 1 changeover contact
• - Installs on left side of FAZ or shunt trip
• - Max. one per FAZ (1077) device
• - Switches when FAZ is tripped electrically or manually

Auxiliary/Trip Indicating Contact

• - Small selector screw changes mode
• - Two Form C (changeover) contacts
• - Installs on left side of FAZ or shunt trip
• - Auxiliary contacts switch when FAZ is tripped electrically or manually
• - Trip indicating contact switches only when FAZ is tripped electrically

Undervoltage Trip

• - Prevents FAZ from operating unless voltage is present
• - Installs on left side of FAZ
• - Includes test button

Shunt Trip

• - Allows remote trip of FAZ
• - Installs on left side of FAZ

Allowable Combinations of Accessories

For connecting FAZ supplementary protectors without auxiliary contacts. May be fed from line or load side.

For connecting FAZ supplementary protectors with auxiliary contacts. May be fed from line or load side.

NOTE: (1) Bus may be center fed for high current capacity.

Pin Type Incoming Supply Terminals

• - Accommodates conductors from 6–35 mm²/#10–2 AWG
• - 4–5.5 Nm/35–50 lb-in
• - Two- and three-pole

Pin Type Incoming Supply Terminals
Single-Phase Only

• - Accommodates conductors from 6–35 mm²/#10–2 AWG
• - 4–5.5 Nm/35–50 lb-in

Protective Accessories

• - Prevents reactivation of the device during maintenance
• - Holds one padlock

Bus Incoming Supply Terminals

• - 50 mm²
• - #14–1 AWG
• - 75 Deg wire
• - 115 A/Y, 480V UL
• - 160 A/Y 690V IEC

Busbar End Cap

• - Install after cutting busbar
• - Protects end of busbar